Installing The Batteries - Newton QuickTake 200 Camera Getting Started

Installing the batteries

1
2
3
6
Chapter 1
Before you begin using your camera, you need to install the batteries. Use
the four lithium batteries (AA size) that came with your camera. To obtain
maximum use from your batteries, turn off the camera whenever you are not
using it.
WARNING Installing the batteries incorrectly may cause an
explosion. Follow the instructions in this manual to replace the
Lithium
batteries. Use only the same type of batteries or an equivalent
(Li)
batteries recommended by the manufacturer of the original
batteries. Do not mix different types of batteries in the camera.
Press down on the Push button and slide and open the battery door.
Insert the batteries into the camera as shown.
Push button
Close the battery door by sliding it into place.
See also: Appendix B, "Battery Information."
Battery door