Step 4: Mount The Speaker To The Bracket - Electro-Voice EVID 3.2 Owner's Manual

Product Description
– L +
– L +
+
–
Left 1
+
–
Left 2
Figure 20: Daisy-chain wiring plan
Step 4: Mount the Speaker to
the Bracket
First remove the two Phillips-head screws
on the rear of the enclosure. Use the sup-
plied eyebolt to mount one mounting clip to
the top of the speaker as shown in Figure
21. Check to make sure that the wiring con-
nections to the amplifier and the satellite
speakers are correct and secure.
For corner mounting
Attach the four rubber mounting feet to the
front side edges, and secure the safety line to
the eyebolt. Lift the enclosure up to the ceil-
ing and center it back it into the corner until
it touches the bracket rungs, then carefully
lower it so the top clip hooks over the top
rung of the bracket (1). Insert one of the 3/8-
16-thread Phillips-head screws through the
remaining clip and, with the clip pointing
up, thread the screw finger-tight into the
lower mtg. hole on the enclosure (2, 3). Level
the clip and tighten securely with a #3 right-
angle Phillips screwdriver. Even though the
EVID Owner's Manual
from
amplifier
– R +
– R +
+
–
Right 1
Right 2
enclosure hangs from the top clip, always
install the lower one to secure against possi-
ble disengagement of the top clip. Straighten
®
the EV logo and press firmly at its center to
seat it securely into its mounting hole.
Figure 21: Corner mounting
For midwall mounting
Attach the four rubber mounting feet inside
the corners on the side of the enclosure that
will be against the wall and attach the safe-
ty line to the eyebolt. Insert one of the 3/8-
16-thread Phillips-head screws through the
remaining clip and keep it within arm's
reach. Lift the enclosure up to the ceiling
and bring its back into contact with the
bracket rungs. Slide the enclosure sideways
to engage the clip over one bracket rung (1)
and, while holding it tight against both
rungs, insert the 3/8-16-thread screw with
its clip into the remaining mounting hole so
the clip engages the remaining bracket
rung (2, 3). Finger-tighten the screw and
straighten the clip. The enclosure may now
be released. It will slide down the rungs
until the four rubber feet are snug against
the wall. Using a #3 right-angle Phillips
screwdriver, securely tighten the second
Phillips-head screw. Gently rotate the EV
logo a quarter turn and press firmly at its
center to seat it securely into its mounting
hole. See Figure 22 on p. 10.
1
3
2
®
9