US Robotics USR9108 - U.S. Robotics Wireless MAXg User Manual page 3

To make the needed connections, follow these steps:
A. Attach the antenna to the back of the gateway.
B. Connect one end of the telephone cable to the telephone port on the back of your gateway (labeled ADSL). Connect the other end to the telephone wall jack.
C. Connect the yellow Ethernet cable. Although you can connect up to four systems this way, you should connect additional devices only after the initial setup is
complete. Insert one end of the Ethernet cable into one of the ports on the back of the gateway (labeled 1, 2, 3, and 4 ). Connect the other end to the Ethernet port on
your computer's network interface card.
D. Plug the AC power adapter into the 9VDC jack on the back of your gateway. Then plug the AC power adapter into a standard wall outlet. If the
panel is not lighted, press the power switch on the back of the gateway.
Not e: This product is intended to be supplied by a UL Listed Direct Plug- in Power Unit marked Class 2 and rated 9V DC, 1200 mA.
The gateway starts up after you turn on the power. This may take one to two minutes.
E. On the front panel, see if the
S t e p 3 . I n s t
1. Insert the U.S. Robotics installation CD- ROM into your computer's CD- ROM drive. The installation should start automatically. This process may take a few
moments.
If the installation does not start automatically, you can start it manually.
Windows Vista users: Click St art , then Comput er and browse to your CD- ROM drive. Open the set up.exe file on the CD- ROM.
Windows users: Click St art and then Run, then type D:\set up.exe in the dialogue box and click OK. (If your CD drive uses a different letter, type that letter in
place of D.)
Macintosh users: Open the CD- ROM and double click on either MacOS X Inst all or MacOS Classic Inst all (depending on which operating system your
and any of the indicators LEDs are lighted. If they are not, see the
a l l E a s y C o n f
t roubleshoot ing sect
i g u r a t o r
LED on the front
ion.
PDFmyURL.com