Table of Contents
Advertisement
4
Using the VIDEO IN/OUT or
White
Red
* To use the VIDEO terminals instead of the
terminal using a BNC cable (commercially available), or connect the TV to the camcorder's VIDEO IN/OUT
terminal using an RCA video cable (commercially available).
We recommend powering the camcorder from a household power outlet.
TV sets equipped with the WSS System: Recordings made with a 16:9 aspect ratio (
be played automatically in widescreen mode whether you connect the camcorder to the TV using
the S (S1-) VIDEO terminal or the VIDEO terminal.
During fast forward playback, rewind playback and reverse playback of a tape recorded in HDV
standard, the picture may be distorted.
Connection to a Standard Definition TV or Monitor
1
Using the COMPONENT OUT Terminal
• Refer to the connection diagram in the previous section (
• Select the appropriate component video signal depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP.OUT], select a setting
option and close the menu.
2
Using the VIDEO IN/OUT or
• Refer to the connection diagram in the previous section (
• If connecting to a TV set with a 4:3 aspect ratio, change the [LETTERBOX] setting appropriately.
Open the menu and select [SIGNAL SETUP]. Select [LETTERBOX], set it to [ON] and
close the menu.
84
(S-Video) IN/OUT Terminal
Open the terminal cover
Stereo Cable (supplied)
Signal flow
S-Video Cable*
(commercially available)
terminal, connect the TV to the camcorder's VIDEO OUT
(S-Video) IN/OUT Terminal
White
Red
83).
84).
INPUT
VIDEO
L
AUDIO
R
S (S1)-VIDEO
38) will
Advertisement
Table of Contents
