Carpet Height Adjustment - Hoover U6420 Owner's Manual

Carpet heiGht adjustMent

2.8 When it is necessary to raise and lower the front of the cleaner for various
carpet pile heights, slide the carpet height control (C) to the desired setting. To
easily adjust the carpet height adjustment, lightly lift the front of the nozzle while
adjusting the height adjustment knob.
For maximum cleaning performance, the following carpet height settings are
recommended:
• Low setting: for all types of carpet.
• Higher settings: for very deep pile carpet where easier pushing effort is desired,
while maintaining good cleaning performance.
If the cleaner is difficult to push, slide control to the next higher setting.
brushroll Control
IMPORTANT
When handle is in upright position, brushroll is
automatically OFF.
2.9 Move the brushroll
control only when the
handle is in the upright
position.
Slide control
"Carpet" to turn
brushroll ON
cleaning carpet
rugs.
Slide control to "Hard"
to turn brushroll OFF
when cleaning bare
floors.
edGe CleaninG
2.11 Special edge
groomers are provided
on both sides of the front
of the cleaner
remove dirt in carpet
near baseboards and
furniture.
Guide either side parallel
to the edge of carpet or
furniture.
Actual model may vary from images shown.
IMPORTANT
2.9
to
for
or
2.11
to
CleaninG liGhtweiGht
flexible ruGs
2.10 Stand on one end
of rug and move cleaner
toward other end or
edge. Before reaching
edge, push down on
handle. This will lift up
the front of cleaner as
shown and will prevent
rug from clinging to
cleaner.
Continue to lift front of
cleaner so that when
you have reached the
edge, it is completely off
the rug. Move cleaner
back to start again,
lower front of cleaner,
and use only forward
strokes.
how to Clean tools
To clean the hose, wipe off dirt with a cloth
dampened in a mild detergent.
damp cloth.
Cleaning tools may be washed in warm water with
a detergent. Rinse and air dry before using.
8
2.8
C
2.10
Rinse with a