, d a m age d , left outdoors ,or dropped into water, take it to a H o over Fa c t o ry Service Center or Au t h o r i zed Hoover Warranty Service Dealer ( D e p o t ) .
(U.S. only) 1-330-499-9499 to speak with a representative in our Consumer Response Center Visit us online at www.hoover.com to find the service outlet nearest you (click on the “Service” button). Carton contents Remove all parts from carton and identify each item shown.
NOTE: Hose must be co 2. How to use Cleaner description 2 - 1 Operate cleaner only at voltage specified on data plate on bottom of cleaner. 2 - 2 ON-OFF Switch Plug cord into electrical outlet. To turn cleaner ON, push switch (A) up. To turn cleaner OFF, push switch down.
2 - 5 Carrying cleaner The cleaner can be lifted by using the carrying handle on the back of the cleaner. 2 - 8 Embedded Dirt FINDER feature (some models only) With red and green lights (C), the ‘Dirt FINDER’ system alerts the user to areas of carpet that may need more cleaning attention.
2 - 1 0 Automatic brush roll indicator When red is in the OFF window, brush roll is STOPPED. When red is in the ON window brush roll is ROTATING. 2 - 1 3 Stair Cleaning Use the hose and powered hand tool or furniture nozzle for stair cleaning.
2 - 1 6 Select proper tool H. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers. I. Furniture nozzle may be used for upholstered furniture, draperies, mat- tresses, clothing, automobile interiors, and carpeted stairs.
3 - 3 To remove loose dirt from the HEPA filter, turn knob (G) on top of dirt cup lid at least one complete turn. 3 - 6 The dirt cup lid is designed with a “breakaway” feature which allows it to snap free if it is pushed open too far.
Do not operate cleaner without the fil- ter in place. Headlight replacement What to buy This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101. 3 - 1 5 Removing lens Disconnect cleaner from electrical outlet.
What to buy To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for flat belt Hoover part No. 38528035. Replacing flat belt Disconnect cleaner from electrical outlet.
Agitator brush roll replacement When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088. 3 - 2 8 How to replace 1. Remove tool from hose and turn it so bottom faces up. Press the latches on either side of tool and remove bottom plate (A).
Pivot bottom plate down and snap closed. Replacing belt When replacing belt, ask for HOOVER part No. 38528037. 1. Remove bottom plate, belt guard and brush roll as described in Figs. 3-28 through 3-30.
OR - • checking the Service section of The Hoover Company on-line at www.hoover.com Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay. Lubrication The motor is equipped with bearings which contain sufficient lubrication for the life of the motor.
4. If you have a problem If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below. Problem: Cleaner won’t run Possible cause Possible solution • Not firmly plugged in •...
The Hoover Company on-line at www.hoover.com This warranty does not cover pick up, delivery, or house calls; however, if you mail your appliance to a Hoover Factory Service Center for warranty service, transportation will be paid one way. While this warranty gives you specific legal rights, you may also have other rights which vary from state to state.
Page 16
HOOVER y son marcas registradas HOOVER et sont des marques déposées HOOVER and are registered trademarks 5-01 U6630-/45-/55-/70-900 Printed in Mexico 56511-B18...