Applying Eq - Yamaha Programmable Mixer 01 Getting Started Manual

15

Applying EQ

Applying EQ

Now we'll apply a little EQ to channel 9. ProMix 01 EQ is 3-band fully
parametric, with variable gain, frequency, and Q.
Setting EQ Gain
1. Press [EQ LOW].
The EQ LCD function shown below appears.
Initially, the LOW gain (G) parameter is selected.
2. Turn the PARAMETER wheel clockwise to boost.
The gain increases in 1dB steps and the EQ curve changes. In the
MEMORY area of the display the word EDIT appears highlighted.
Don't worry about it at this stage. It just means that the mix settings
have changed (i.e. they are different to the 00 InitData mix scene).
Note: Applying a lot of EQ boost may increase the signal level sufficiently
to cause distortion. If this does occur, reduce the amount of EQ boost or
back off the GAIN control a little. Note that the METER LCD function
shows pre-EQ signal levels. So you'll have to use your ears for this one.
3. Turning the PARAMETER wheel counterclockwise, set the gain
back to 0dB.
ProMix 01 Getting Started Guide