Cleaning The Magic Filter; How To Put The Detergent In; How To Add The Fabric Softener; How To Clean The Filter - Samsung WA200 Owner's Instructions Manual

CLEANING THE MAGIC FILTER

1. Push the upper part
of the filter and pull in.

HOW TO PUT THE DETERGENT IN

1. Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent may
not brim over the box.

HOW TO ADD THE FABRIC SOFTENER

When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
Do not use detergent, bleach or starch into
the Softener Inlet.
Using too much softener may produce
unsatisfactory results.
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
Washing machine won't work
Is the water tap opened?
Is the washer plugged in?
Is the power cut off?
Is there enough water?
Water is not supplied
Is the water tap opened?
Is the water cut off?
Is the water supply hose or hose
connection clogged?
Is the water tap frozen?
If water is not supplied in 1 hour,a
buzzer will sound.
Power won't cut off
This sign means power is not cut
off automatically.
Make sure there is lighting
on the lamp whenever press the
power button.
2. Open the cover as
shown in the figure.

HOW TO CLEAN THE FILTER

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
Pour it slowly
3. Clean the filter. 4. Close the cover and insert t

TROUBLESHOOTING

Water dose not drain
Is the drain hose down?(No pump)
Is the drain hose frozen?
Is the drain hose clogged?
If the water dose not drain in 6
minutes, a buzzer will sound.
Spinning does not work
Is the laundry spread out evenly
in the washer?
Is the washer set on a sturdy
flat surface?
Water is overflowed
Restart after spinning.
If the error sign still indicates,
call agency.
he lower part of the filter in the
basket first and then push the
filter with "click" sound .
8