Check Rotating Brush And Drive Belt; Replace Drive Belt - Samsung SU8583 Operating Instructions Manual

Check Rotating Floor Brush and Drive Belt
1 Unplug cleaner from electrical outlet.
2 Place handle in Low position and turn vaccum cleaner
over so bottom side is up.
Remove the eight screws as shown with a screwdriver.
3
4 Turn over the cleaner again, and lift the Cover-Brush off.
Remove the eight screws, and lift the Brush Cover off.
5
6 Grasp Rotating Floor Brush at both ends and lift.
7 Clean strings, hair and other debris from Rotating Floor
Brush, paying particular attention to brush ends.
8 Clean strings, hair and other debris from Motor Pulley
and Drive Belt areas.
9 Check Drive Belt carefully for wear, cuts or stressed
areas.
Check Air Passageway for obstructions. Remove debris
10
from this area.

Replace Drive Belt

1 Unplug cleaner from electrical outlet.
2 With Rotating Floor Brush removed from vaccum
cleaner(Step1-6 of Check Rotating Floor and Drive Belt)
grasp old Drive Belt and remove from Motor pully.
Discard old Drive Belt.
Place new Drive Belt over motor pulley and stretch other
3
end over rotating Floor Brush in the space between the
bristles.
4 Place ends of rotating Floor Brush down into slots on
sides as shown.
Turn rotating Floor Brush by hand several times in
5
direction of motor pulley, if properly installed, Drive Belt
will center itself.
6 Reposition Brush cover and eight screws. Tighten
screws securely. Snap end of Brush cover into place.
M a i n t e n a n c e
10