Table of Contents
Advertisement
Selecting the RF OUT Sound
Mode (B/G-D/K)
You can choose the sound mode (B/G or D/K)
according to the TV set connected to your VCR.
1
Press MENU on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the INSTALLATION option.
3
Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4
Press the corresponding
TV SYSTEM option is selected.
INSTALL
AUTO SET UP
MANUAL SET UP
TV SYSTEM
:K
VCR OUTPUT CH :CH36
❿
END:
❷
❿
5
Press the
button to select K or G.
6
On completion, press MENU twice to exit the
menu.
Presetting the Stations
Automatically
You do not need to preset the stations if you have
already set them automatically (see Plug & Auto
Set Up on page 11).
Your VCR contains a built-in tuner used to receive
television broadcasts.
You must preset the stations received through the tuner.
This can be done:
Plug & Auto Set up (see page 11)
Automatically
Manually (see page 15)
You can store up to 80 stations.
1
Press the MENU button on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the INSTALLATION option.
➛
❿
,
or
,
buttons to
❷
or
buttons, until the
❷
MENU
➛
❿
,
or
,
buttons to
❷
ENG-14
INSTALL
PROG
OPTIONS
INSTALL
CLOCK
BONUS
LANG
INSTALLATION
➛❿
OK
END:
❷
3
Press the OK button to select this option.
Result: The INSTALLATION menu is displayed.
4
Press the corresponding
AUTO SET UP option is selected. And then press
❿
the
button to select this option.
5
Press OK to start the auto scanning.
Result:
The PLEASE WAIT indication flashes on
the television screen.
The first frequency band is scanned and
the first station found is displayed and
stored.
The VCR then searches for the second
station and so on.
When the automatic scanning procedure
has finished, the VCR switches
automatically to programme 1.
The number of stations automatically stored by the
VCR depends on the number of stations that it has
found.
6
If you wish to cancel the auto scanning before the
end, press the MENU button three times to exit the
menu.
Once the auto scanning procedure has finished,
some stations may have been stored more than
once; select the stations with the best reception
and delete the ones no longer required (see page
16).
Activating the DECODER:
1
Select the station using the PROG/TRK (
).
❷
2
Select the INSTALLATION option (see page
15).
3
Select the Manual Set up option.
4
Press the
or
❷
in front of the DECODER.
Press the ❿ button to activate use of
5
DECODER for the TV station.
6
Press OK to store the station.
7
Press Menu three times to exit menu.
MENU
or
buttons, until the
❷
or
buttons to place the cursor
Advertisement
Table of Contents
