Table of Contents
Advertisement
VCR
GB
1
Standard
ShowView
Code
STANDBY/ON
5
32
Using the ShowView
OK
Timer Method
ShowView
Code
: 0 - 9
Correct
:
OPEN/CLOSE
Before presetting your DVD-VCR:
Switch on both the television and your DVD-VCR
Check that the date and time are correct
Insert the cassette on which the programme is to be
recorded (safety tab intact)
Up to six programmes can be preset.
1
To enter a
ShowView
and OK or ❿ buttons to select
Press the
or
❷
Result:
A message is displayed to allow you to enter the
ShowView
If all six programmes have been set, the message
is full
is displayed. Refer to page 35 if you wish to
cancel a preset recording.
2
Press the numeric buttons to enter the code opposite the
programme that you wish to record in your television magazine.
If you wish to correct the
entering:
Press the ➛ button until the digit to be corrected is
cleared
Enter the correct digit
3
Press the OK button.
Result:
The information concerning the programme is
displayed.
When using the
stored stations, the programme number flashes. This one
time, you must enter the station number manually by
pressing the
if:
The programme number or times flash
You wish to modify the programme
4
If the programme and times are correct, press the RETURN
button.
5
Press the STANDBY/ON button to activate the timer.
6
Refer to page 35 if you wish to:
Check that your DVD-VCR has been programmed correctly
Cancel a preset recording
The numbers next to each TV programme listing are
ShowView code numbers, which allow you to
programme your videorecorder instantly with the
remote control. Tap in the ShowView code for the
programme you wish to record.
™ ShowView is a trademark of Gemstar Development Corporation. The ShowView system
is manufactured under licence from Gemstar Development Corporation.
, press the TIMER button.
ShowView
code.
ShowView
code that you are
function for the first time with
ShowView
or
buttons. Refer to the following page
❷
Timer
Advertisement
Table of Contents
