Table of Contents
Advertisement
Deciding How to Connect DVD-VCR
GB
You must take into account various factors when connecting audio or video systems:
Types of connectors available on your systems
Systems connected permanently to the DVD-VCR (satellite receiver for example) or temporarily
(camcorder for example)
Your DVD-VCR is equipped with the following connectors.
Connector
Location
Type
MIC JACK
Front
MIC JACK
MIC 1
MIC 2
Audio output
Rear
Audio RCA
LINE
Rear
Audio/Video
RCA
COMPONENT Rear
RCA
output
S-VIDEO
Rear
S-JACK
output
Digital AUDIO Rear
Optical
output
coaxial
OUT TO TV
Rear
75
coaxial
IN FROM ANT. Rear
75
coaxial
Whenever you connect an audio or video system to your DVD-VCR, ensure that all elements are
switched off.
Refer to the documentation supplied with your equipment for detailed connection instructions and
associated safety precautions.
10
Direction
Recommended Use
In
MIC
Out
Audio out (DVD only)
In/Out
Television
Other VCR
Out
COMPONENT out (DVD only)
Out
S-Video out (DVD only)
Out
Digital Audio out (DVD only)
Out
Television
In
Aerial
Cable television network
Satellite receiver
Connecting DVD-VCR to the TV using the Coaxial Cable
To receive television programmes a signal must be received from
one of the following sources:
An outdoor aerial
An indoor aerial
A cable television network
A satellite receiver
Make sure that both the television and the DVD-VCR are
switched off before connecting the cables.
1
Remove the aerial or network input cable from the television.
2
Connect this cable to the 75 coaxial socket marked
rear of your DVD-VCR.
3
Plug the coaxial cable supplied into the
TV
socket on your
DVD-VCR.
4
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
5
To obtain better quality pictures and sound on your television, you
can also connect your DVD-VCR to the television via the RCA
cable (see section below) if your television is equipped with this
type of connection.
Connecting DVD-VCR to the TV using the RCA Cable
TV
3
RF coaxial cable
You can connect your DVD-VCR to the television using the RCA cable if the appropriate input is available on
the television. You thus:
Obtain better quality sound and pictures
Simplify the setting up procedure of your DVD-VCR
Regardless of the type of connection chosen, you must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the screen when the DVD-VCR is switched off.
Make sure that both the television and the DVD-VCR are switched off before connecting the cables.
1
Connect the coaxial cable as indicated in the above section.
2
Connect one end of the RCA Audio/Video cable to the Video output and Audio L, R output socket on the rear of
the DVD-VCR.
3
Plug the other end into the appropriate connector on the television.
GB
2
on the
TV
4
3
Aerial
2
11
Advertisement
Table of Contents
