Samsung DVD-V642K Instruction Manual page 6

Setting Up Your DVD-VCR
Copying from DVD to VCR
The DVD-VCR allows you to copy the contents of a DVD to a VHS tape with a press of the
COPY button.
If the DVD you are attempting to copy is copy protected, you will not be able to copy the disc. It
is not permitted to copy Macrovision® encoded DVDs.
1 Insert Disc
Insert the disc you wish to copy in the DVD deck and close the drawer.
2 Insert VHS Tape
Insert a blank VHS videotape into the VCR deck.
3 Copy the DVD to VHS Tape
Press the COPY button on the DVD-VCR front panel.
• The DVD will go into Play mode and the VCR will go into Record mode.
• If the DVD disc menu appears, you may need to press the PLAY button manually to
begin copying.
4 Stop the Copy Process
When the DVD is finished playing, press the VCR button on the remote control and then
press the STOP button to end the copy.
• You must stop the Copy process manually when the DVD movie ends or the DVD may
replay and record over and over again.
Selecting the Cassette Type
If you wish to use the tape counter to display the time remaining on a cassette, you
must indicate the type of cassette inserted.
1 After pressing the menu press the corresponding
option.
2 Press the OK or ❿ buttons to select this option.
Result: The VCR Setup menu is displayed.
3 Press the corresponding or ❷ buttons, until the Tape Select option is selected.
4 Press the OK or ❿ buttons as many times as required, until the correct cassette
length is displayed.
E180 E240
E 300 E260
5 Press RETURN twice to exit the menu.
Repeat Play
You can set repeat play to repeat the tape continuously from beginning to end.
To... Press OK or
Repeat play On is displayed.
Do not wish to repeat play Off is displayed.
❷ buttons to select the VCR
❿
, until...
6