Phone Installation
Installing the Base Set
�
When you have finished installing the base set, press the "speaker phone" button.
�
If you cannot hear a dial tone, then check both the power and the phone line connections.
�
This product works only at 220V.
Installing the Remote Set
휴대장치 설치
�
Place the remote set on the charger and check if the lamplight is on.
�
Press the call button and check for a dial tone.
�
If you cannot hear the tone, check the installation.
To turn on / off the power
�
To turn on the power : Press
hear the beeping sound.
�
If it does not turn on when you press
remote set. It should then turn on automatically. Please recharge the battery for 24 hours
before using it.
�
If you do not charge the battery for at least 6 hours, then in order to protect it, the battery
must be fully charged or it will stop operating.
�
To turn off the power : Press
9
the beeping sound.
Pay extreme attention when
connecting both the power line and the
phone line.
or
DC11V 500mA
DC 9V 150mA
DC12V 500mA
button (hold for more than 2 seconds) until you begin to
button, then you probably need to recharge the
buttons (hold for more than 3 seconds) until you hear
Loading the battery to the remote set
Connect the phone line.
Open the
1
battery cover.
Connect the power
plug to 220V.
How to use the Battery
● Charge the battery for approximately 24
hours before using.
● Always remove the battery from the
remote set. when you are not using the
remote set for an extended period.
● Charge the battery until you see
Connect the power
plug to 220V.
Battery Life
Place the
Rearrange the
Close the
2
3
4
battery as
line by setting
battery cover.
shown in the
the battery as
picture.
shown in the
picture.
@@
@@ @@
.
● The battery life has a 6 months warranty after
purchase.
● As time goes by, there will be a reduction in the
battery' s power. When battery's power capacity is
reduced by half, purchase a new battery and replace it.
● Please contact your local Samsung Electronics
Service Center on how to purchase and replace the
battery.
10