Checking - Samsung VP-L906 Owner's Instruction Manual

Troubleshooting Check

Checking

✤ If you run into any problem using the camcorder, use the following table to try to resolve the problem.
✤ If these instructions do not allow you to solve the problem, take a note of:
I The model and serial number marked on the bottom of the camcorder.
I Your warranty, if applicable.
✤ Then contact your nearest Samsung authorized service centre.
Symptom
You cannot switch the camcorder on.
Start/Stop does not
operate while shooting.
The camcorder goes off automatically.
The battery pack is quickly exhausted.
You cannot eject the
cassette from the compartment.
The DATE/TIME indicator flashes
more than 2 times when you
set the camcorder to CAMERA.
The playback picture is in poor quality.
You can do nothing with the camcorder.
N
Check the battery pack (see page 19)
or the AC power adapter. (see page 18)
N
Check the POWER, set it to CAMERA.
N
You have reached the end of the cassette.
N
Check the record protection tab on the cassette. (see page 22)
N
You have left the camcorder set to STANDBY
for more than 5 minutes without using it.(see page 24)
N
The battery pack is fully used up. (see page 21)
N
The atmospheric temperature is too low. (see page 21)
N
The battery pack has not been charged fully.(see page 19)
N
The battery pack is completely dead, and cannot be recharged.
Use another battery pack.
N
The battery pack is fully discharged.
N
A mechanical fault may have occurred. (see page 64)
N
The lithium battery is not installed or is fully used up. (see page 17)
N
The video heads might be dirty. (see page 58)
N
A mechanical fault may have occurred. (see page 64)
Explanation/Solution
ENGLISH
65