Method Of Installation - Samsung AHT18F1MBA Owner's Instructions Manual

Method of Installation

Rear
Rubber cap
Gasket
Drain Tube
Screws(2EA)
Safety clip
Front panel
14
E-
Installation of the Drain Tube
Fix the drain tube as shown in the figure.
Installation of the Drain Pan
The procedure for installing the drain pan should be determined by the
condition of the installing area.
In the case of an area where the drain pan can not be directly
installed on the rear side of the unit after installing the air conditioner.
Example: High storage
1 Open the front grille.
C C A A U U T T I I O O N N
C C A A U U T T I I O O N N
Removal and Reassembly of the Front Grille
For user's safety, a safety clip has been installed in the front grille.
1 Grasp the lower part of the front grille and the air filter handle, then
open the grille.
2
Remove the safety clip and the front grille.
3 When reassembling the front grille, you should install the safety
clip again.
2 Remove the front panel.
2-1 Press both sides of the cabinet in the direction of the arrow
as shown in the figure.
2-2 Pull the lower part of the front panel slightly forward.
(below three inches)
2-3 Lift the front panel upward.
Applying excessive force to remove the front panel
may cause damage to the tab ; be sure not to use
excessive force.
3 Remove two screws on the lower, right and left sides of the unit.