Advertisement
Electrical Section
For maximum electro-luminescent life, do not wire lighting to direct igntion switched 12-volt source. The lighting power source
should be routed through OEM dash controls, or a separate rheostat. Power can be achieved by tapping into the factory dash lighting
through either the fuse panel or from a 12-volt dash light wire. This will allow you to control the light intensity. Use the appropriate
connectors for your particular application. The white wire must be connected to the power source and the black wire to a good
ground. Damage to electronic circuits could occur if connected incorrectly.
Qty.
1
0-15 psi Fuel Pressure Gauge
1
Gauge Light with Harness
2
Star Washers
2
Attaching Screws
1
Gauge Bracket
1
Red Light Cover
1
Green Light Cover
©2001 Edelbrock Corporation
Rev. 7/01
Bill of Materials
Description
Edelbrock Corporation
2700 California Street
Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Office: 310-781-2222
Tech E-Mail: edelbrock@edelbrock.com
Qty.
1
0-100 psi Fuel Pressure Gauge
1
Gauge Light with Harness
2
Star Washers
2
Attaching Screws
1
Gauge Bracket
1
Red Light Cover
1
Green Light Cover
Page 2 of 2
Description
Catalog #73827 & #73829
Brochure No. 70-4686
Advertisement
