Advertisement
1.
Install your new Adjustable Control Module onto the
backing plate in the same location as the Control Module
that you just removed. Install the module so that the
adjustment controls are located on the bottom of the
module (Fig. 5).
2.
Connect the black ground wire off of the adjustable
module, labeled "GND" to the backing plate using the bolt
that you previously removed (Fig. 5).
3.
If using a Single Fire Ignition, leave the gray wire labeled
"SF/DF" loose and tape or cut and apply a butt connector
to the end of the wire so that it cannot contact anything. If
using a Dual Fire Ignition, connect the gray wire labeled
"SF/DF" to the same bolt as the black ground wire off the
adjustable module (Fig. 5).
4.
Route the blue and black fuel pump wires, labeled "PUMP", through
the wire port on the backing plate. Connect the blue fuel pump wire
to the positive (+) terminal of the nitrous system fuel pump and the
black fuel pump wire to the negative (-) terminal of the nitrous
system fuel pump (Fig. 6).
5.
Connect the two black male solenoid clip terminals to their
corresponding female clip terminals routed through the wire port of
the backing plate (Fig. 5). Be sure that you connect the "FUEL"
terminal to the fuel solenoid wire terminal and the "NOS" terminal to
the nitrous solenoid wire terminal.
6.
Route the red and green wires through the wire port of the backing plate. Connect the green wire, labeled "TACH",
to the tach lead. Leave the red wire disconnected at this time.
7.
Using the wire clamp that you previously removed
during the Nitrous Control Module removal, route all of
the excess wire that is now in the housing through the
loop and mount this clamp in its original location, such
as depicted in Fig. 3.
7.
Connect the orange wire, labeled "ARM", to the top
terminal of the Arming Switch. Connect the remaining
wires that you previously disconnected from the
arming switch to their appropriate terminals on the
switch.
8.
Install the Chrome Cover Plate using the four bolts and
washers that you removed previously.
9.
Connect the red wire, labeled "13.8V", to the battery or
key activated circuit breaker.
10.
Your Adjustable Control Module has been supplied with an adjustment settings sticker for your convenience. This
sticker can be mounted wherever you feel is convenient, but we recommend placing the sticker on the inside of
the Chrome Cover Plate as depicted in Fig. 7. This will keep the sticker from being misplaced, as well as be
located in a convenient location for reference when you are adjusting your settings.
2004 Edelbrock Corporation
Brochure #63-0131
INSTALLATION
Page 2 of 4
Fig 5
Fig 6
Fig 7
Catalog #72230
Rev. 5/04
Advertisement
