Clock/Timer; View Clock; Clock Setting - Philips MCI200/21M Manual

Clock/Timer

IMPORTANT!
When in Eco Power standby mode, it is
not possible to operate the clock or
timer function.

View clock

The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(CD or TUNER for example)
Press CLK /TIMER on the remote control.
The clock is displayed for a few seconds.
If the clock has not been set, "--:--
displayed.

Clock setting

The clock can be set in either 12-hour or
24-hour mode (" 12:00 A 12:00 AM M M M M " or " 00:0
12:00 A 12:00 A 12:00 A
example).
1
In standby or view clock mode, press
CLK/ TIMER once. In any other source
modes, press CLK/ TIMER twice.
" 12:00 A 12:00 AM M M M M " or "00:00 00:00" starts flashing.
12:00 A 12:00 A 00:00 00:00
12:00 A 00:00
Press the left hand soft key ( @) to select 12- or
2
24- hour clock mode.
30
Press S or T (or ¡ / ™ on the remote
3
control) to switch between hour or minutes
setting.
Use the navigation jog (or press 3 / 4 on the
4
remote control) to set the hour and minutes.
5
Press CLK / TIMER again to store the setting.
To exit without storing the setting
Press Ç.
Notes:
--:--" is
--:-- --:-- --:--
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
00:00 0 0 0 0 ", for
00:0 00:0 00:0 mode automatically.
– To set the clock automatically through the time
information in the RDS signal, refer to "Radio
Reception - Setting the RDS clock".
The hour or minutes digits flash.
The clock starts working.