Table of Contents
Advertisement
Connecting to a TV and a two-channel Stereo
(Stereo has Dolby Pro Logic or right/left Audio In jacks)
4
1
Connect your Antenna or Cable TV signal to the ANTENNA
jack on the rear of the DVD Recorder.
2
Connect the supplied S-Video cable to the S-VIDEO OUT
(Y/C) (EXT 1) jack of the DVD Recorder and to the TV's
S-VIDEO IN jack.
3
Connect a supplied two-strand audio cable to the red and
white AUDIO OUT (EXT 1/2) left and right jacks on the
DVD Recorder and to the left/right AUDIO IN jacks on the
Stereo. The supplied two-strand audio cable has red and white
stripes on the cable ends. Match the cable stripe colors to the jack
colors.
4
Connect the supplied power cord to the MAINS (AC
Power) jack on the rear of the DVD Recorder.
Connect the power cords of the DVD Recorder, Stereo,
and TV to a power outlet.
5
Turn on the Stereo power and set your Stereo to the cor-
rect Audio In channel or sound source. Refer to the Stereo
owner's manual.
6
Press the STAND BY/ON button on the front of the DVD
Recorder to turn on the DVD Recorder. The STAND BY/ON
light will turn green.
7
Turn on the TV power. Set the TV to the correct S-Video In
channel. These channels often are near channel 00. See your TV
owner's manual for details. Or, change channels at the TV until you
see the DVD screen saver or Initial Setup menu on the TV screen.
The Initial Setup screen will appear the first time you turn on the
Recorder. Go to page 16 to continue.
Back of TV
(example only)
S-AUDIO IN
Antenna
or Cable TV
Signal
2
EXT 2
EXT 1
1
Stereo
(example only)
RIGHT AUDIO IN
S-VIDEO IN
LEFT AUDIO IN
EXT 3
EXT 3
COMPONENT VIDEO
PROG
SCAN
Y
Y
Y
L
L
P
P
P
L
B
B
B
R
P
P
P
R
R
R
R
R
EXT 1/2
Hookups (cont'd) 13
3
IN
RC 6
Helpful Hints
• Set the Analog output accord-
ingly. Details are on page 57.
• If you prefer or need to use the
VIDEO OUT (CVBS) or COM-
PONENT VIDEO OUT Y P
jacks instead, see pages 10 and
12. You only need one video
connection.
P
B
R
Advertisement
Table of Contents
