Table of Contents
Advertisement
4
1
Connect your Antenna or Cable TV signal to the ANTENNA
jack on the rear of the DVD Recorder.
2
Connect the supplied S-Video cable to the S-VIDEO OUT
(Y/C) (EXT 1) jack of the DVD Recorder and to the TV's S-
VIDEO In jack.
3
Connect a supplied two-strand audio cable to the red and
white AUDIO OUT (EXT 1/2) left and right jacks on the
DVD Recorder and to the left/right AUDIO IN jacks on the
TV. The supplied two-strand audio cable has red and white stripes
on the cable ends. Match the cable stripe colors to the jack colors.
4
Connect the supplied power cord to the MAINS (AC
Power) jack on the rear of the DVD Recorder.
Connect the power cords of the DVD Recorder and the TV
to a power outlet.
5
Press the STAND BY/ON button on the front of the DVD
Recorder to turn on the DVD Recorder. The STAND BY/ON
light will turn green.
6
Turn on the TV power. Set the TV to the S-Video In chan-
nel. See your TV owner's manual for details. Or, change channels at
the TV until you see the DVD screen saver or Initial Setup screen
on the TV screen. The Initial Setup screen will appear the first time you
turn on the Recorder. Go to page 16 to continue.
Connecting to a TV Only
TV has an S-Video In Jack
2
Antenna
or Cable TV
Signal
EXT 2
EXT 1
1
Back of TV
(example only)
RIGHT AUDIO IN
LEFT AUDIO IN
S-VIDEO IN
EXT 3
EXT 3
COMPONENT VIDEO
PROG
SCAN
Y
Y
Y
L
L
P
P
P
L
B
B
B
R
P
P
P
R
R
R
R
R
EXT 1/2
Hookups (cont'd) 11
RIGHT AUDIO IN
LEFT AUDIO IN
S-AUDIO IN
3
IN
RC 6
Helpful Hint
• On the TV, the S-Video In jack
may be labeled Y/C, S-Video, or
S-VHS (super video).
Advertisement
Table of Contents
