Appendix - Panasonic WJ-FS616C Operating Instructions Manual

Video multiplexer
Hide thumbs Also See for WJ-FS616C:
Table of Contents

Advertisement

APPENDIX

This Appendix details the elements for communication between the Video Multiplexer and the personal computer. For BAUD
RATE, DATA BIT, STOP BIT and PARITY settings, see page 42 COM PORT SETUP menu.
Communication Protocol
1. Transmission Command
The PC sends messages to operate the Multiplexer in the format shown below. Also refer to the command table shown
later.
A transmission message consists of [STX], [Address], [;], [Transmission Command], and [ETX]. [Address] is expressed as
"ADuu,"where 'uu' is in the range of "00" through "16" in decimal form to identify the unit number of the Video Multiplexer.
When using the RS-232C port to communicate with the PC, [Address] and [;] can be omitted.
2. Response Command
The Multiplexer returns messages in reply to the PC's messages with the following formats.
(1) Reception completed
When the reception was completed successfully, the Multiplexer sends back "ACK code, 06H", followed by parameters.
The response command is shown in the Command Table.
(2) Reception error
The Multiplexer sends back "NAK code, 15H", followed by the parameters shown below. The Multiplexer then resets the
reception buffer and enters waiting mode for the next message. Parameter "e" identifies the error status.
(3) Parameter error
The Multiplexer returns "ACK code, 06H", the transmission command that was not processed properly for some reason,
followed by an error code as shown below.
Note: The Video Multiplexer returns [ACK] or [NAK] to the PC within 20 ms after the reception of [ETX] in a transmission mes-
sage.
78
Code
[STX] [Address] [;] [Transmission Command] [ETX]
ASCII
(02H) (
) – – – – – – – – – – – – – – – – – (
Code
[STX] [Address] [;] [Response Command] [ETX]
ASCII
(02H) (
Code
[NAK] [e]
ASCII
(15H)
"e" value
1: Parity error
2: Data Over error
3: Framing error
4: Overrun error
5: Time Out error
Code
[STX]
[Transmission Command]
ASCII
(02H) (
Error code
ER001: Command invalid
ER002: Parameter invalid
ER301: Command legal but out of range
ER302: Parameter legal but out of range
) – – – – – – – – – – – – – – – (
[:]
) – – – – – – (
) (3AH) (
) (03H)
) (03H)
[Error Code]
[ETX]
) – – – (
)
(03H)

Advertisement

Table of Contents
loading

Table of Contents