The System Control Connections - Kenwood KAF-1010 Instruction Manual

The system control connections

Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown below.
[XS8 ] Mode : lets you combine F , f, and ƒ terminals
[SL16] Mode : for
This unit corresponds to [XS8] and to [SL16].
÷ When all units in system control connection are set to [XS8] mode, set the SYSREM CONTROL selector switch on the rear to the
[XS8] side and connect.
÷ When all units in system control connection are set to [SL16] mode, set the SYSREM CONTROL selector switch on the rear to the
[SL16] side and connect.
SYSTEM CONTROL
selector switch
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for
system operations. If your equipment consists of this kind of combination, please
Notes Notes
do not connect any system control cords, Even without system control cords,
normal operations can be carried out without affecting performance.
2. If your amp or receiver does not have a system control terminal, do not connect
any system control cords to the system control terminals on the other compo-
nents.
3. Do not connect system control cords to any components other than those speci-
fied by KENWOOD. It may cause a malfunction and damage your equipment.
4. Be sure the system control plugs are inserted all the way in to the system control
terminals.
The system control operations
Remote Control
The remote control supplied with this unit can also be used to control the other components in the system.
Automatic Operation (except [XR] equipment)
Automatically switches the input selector on the amp or receiver when you start playback from this unit.
Synchronized Recording (except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD, MD, or LD.
terminals only
SYSTEM CONTROL
ƒ
SL 16 XS-8
SYSTEM CONTROL
ƒ
SL 16 XS-8
SIGNAL GND
PHONO CD TUNER TAPE MD
REC PLAY REC PLAY
L
R
(only for KAF-3010R)
No matter to which of the two terminals
the connection is made, the use method is
the same.
SPEAKERS
AC OUTLETS
i A or B : 4–16 , A and B : 8–16 j
L R
A
+ – – +
B
UNSWITCHED SWITCHED TOTAL
100W MAX. 200W MAX.
L R
KAF-3010R/1010 (En)
5