System Connections - Kenwood KA-880SD Instruction Manual

System connections
O
=
[Except U.K., European, Australian countries
egwirenes
ee (fe)
eorrcat,
LIBR LIER
LINE IN LINE OUT
Evol
= c= Jobleae 29
Speakers
This amplifier has two pairs of speaker terminals,
SPEAKERS A and SPEAKERS B.
Connecting one speaker system
Connect speakers rated at 4 ohms or more to the
SPEAKERS A terminals.
Connecting two speaker systems
To connect an additional pair of speakers, use the B ter-
minals. In this case, each speaker must be rated at
8 ohms or more.
Ne
1. During speaker systems connection, set the POWER switch to
OFF.
2. Check that the connected lead wires of the speaker systems do
not contact other jacks or terminats
3. When connecting one pair of speakers to the SPEAKERS A or B
terminals, be sure that the impedance of each speaker is between
4 and 16 ohms. When connecting speakers to both SPEAKERS A
WARNING!
Remove insulation
et og) from lead tip.
oo
as far as it will go. clockwise to tock contact. pull the
the wire. wire slightly.
Connecting speaker cords
oe Twist wire tightly,
and solder.