Advertisement
D. Reattach the L-shaped bracket (if one was removed) and
set the pump into the pump support. Connect the fuel
hose using the supplied clamps. Make sure the fuel pump
is seated properly into the pump support.
E.
Attach the electrical connectors to the pump.
4.
Fuel Pump Assembly Installation:
A.
Inspect fuel tank for dirt and debris. If the amount of dirt
or debris in the tank is excessive, clean the fuel tank
before installing the fuel pump assembly.
B. Inspect the assembly to make sure it is clean and ready for
installation.
C. Replace the o-ring seal or gasket if worn or cracked.
D. Insert the assembly, being careful not to damage the fuel
filter. Tighten the mounting nuts and secure the assembly
to the fuel tank.
5.
Fuel Pump Fitting Installation:
A.
Install the plastic insert to the 8mm to -6AN EFI adapter
fitting over the outlet line of the fuel pump (See Fig. 11) .
Figure 11 - EFI Adapter Fitting Insert
B. Install the adapter fitting over the plastic insert. Press the
adapter over the insert until it locks into place (See Fig.
12) .
Figure 12 - EFI Adapter Fitting
FUEL LINE ROUTE PREPARATION:
1.
Determine the best route for your application. In our installation, we
used the factory fuel line routing. To do so, we removed the factory
fuel line cover and removed the factory supply and return hard lines
(See Fig. 13) .
Catalog #641560, 641563
Rev. 10/07 - AJ/mc
Figure 13 - Factory Fuel Line Removed
2.
To provide enough clearance to fit the fuel supply and return lines,
we removed a tab from the fuel line support clips (See Fig. 14) .
Figure 14 - Cutting Fuel Line Support Clips
3.
Fuel Filter Installation:
NOTE: Use fitting assembly lube when assembling hose ends.
Use AN wrenches if available, and DO NOT OVERTIGHTEN
FITTINGS. See Russell catalog or contact the Edelbrock Tech
Line for details.
Figure 15 - Fuel Filter Assembly
A.
Asssemble the fuel filter and inlet/outlet fittings (See Fig.
15) .
B. This fuel line kit will not use the factory fuel filter. Remove
the factory fuel filter if it has not been previously removed.
In our installation, we chose to mount the fuel filter on the
firewall in-line with the original fuel line path to the factory
fuel filter. You may chose a different location for your
particular application.
determined, mount the fuel filter to the chassis, using the
hardware provided.
Page 5
When the location has been
©2007 Edelbrock Corporation
Brochure #63-641560
Advertisement
