Edelbrock Russell 641550 Installation Instructions

Please study these instructions carefully before installing your new complete fuel system kit. If you have any questions, please call
our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us at
Edelbrock@Edelbrock.com.
KIT CONTENTS
❑ 1
Fuel Pressure Regulator Kit #1728
❑ 3
3/8" NPT x -6 AN male adapter
❑ 1
3/8" NPT x -6 AN male adapter w/ 1/8" NPT port
❑ 1
Mustang 5.0 fuel rail kit
❑ 2
-6 AN dry sump union
❑ 1
-6 AN plug
❑ 6
Tie wraps
❑ 10 ft. -6 hose
❑ 3
-6 AN Straight hose end
❑ 1
-6 AN 45° Swivel hose end
❑ 4
-6 AN 90° Swivel hose end
❑ 1
-6 AN to Ford Pressure side fitting
❑ 1
-6 AN to Ford Supply side fitting
❑ 1
Assembly lube/sealant kit
❑ 1
0 - 100 psi fuel pressure gauge
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in
MAKE SURE TO DISCONNECT YOUR BATTERY TO AVOID THE POTENTIAL FOR SPARKS IN THE WORK AREA!
SOME PROCEDURES IN THIS INSTALLATION WILL REQUIRE THE VEHICLE TO BE RAISED ON JACKSTANDS OR A LIFT. WHEN
RAISING A VEHICLE, MAKE SURE THE VEHICLE IS ON LEVEL GROUND AND SUPPORTED SECURELY BY JACKSTANDS.
© 2007 Edelbrock Corporation
Brochure No. 63-641550
poor performance and engine or vehicle damage.
NEVER WORK UNDER A VEHICLE THAT IS SUPPORTED BY A JACK ONLY!
FORD 5.0L EFI FIREWALL FORWARD RUSSELL
TOOLS & SUPPLIES RECOMMENDED
❑ Basic hand tools
❑ AN Wrenches
❑ Drill motor & bits
❑ EFI fuel line disconnect tool
❑ Miscellaneous hardware for mounting components
(including nuts & bolts)
Gasoline and gasoline fumes are extremely
flammable. Work in a well-ventilated area away from
open flames, sparks, or other sources of ignition. Try
to contain gasoline when connections are loosened,
and clean up any spills immediately. Failure to do so
can result in a fire or explosion.
IMPORTANT NOTE:
WARNING:
Page 1 of 4
PLUMBING KIT
Catalog #641550

INSTALLATION INSTRUCTIONS

WARNING!!!
Rev. 10/07 - AJ/mc
Catalog #641550