Installation - Kenwood KTC-9090DAB Instruction Manual

Installation

Mounting the DAB Antenna to the Roof
2WARNING
• If a hole to insert the antenna has burrs, remove them first.
Leaving burrs causes damage to the antenna cable leading
to accidents and failures.
2CAUTION
• Make a hole in the roof and mount the DAB antenna.
Specialized knowledge is required for this job and an installer
should be requested for the installation work.
• The DAB antenna should be mounted so that it does not
protrude beyond the width and length of the car.
• Do not install at a spot where the roof is markedly curved.
Doing so will allow water to enter from a gap between the
roof and the waterproof rubber.
• Securely fasten the screws that fix the DAB antenna as well
as the screws of the DAB antenna itself. Screws that loosen
introduce the danger of the antenna coming apart during
travel.
1
Determine the mounting position of the DAB
antenna. (It replaces with established FM / AM
antenna.)
2
Wipe away any dirt from the mounting position.
3
Remove the lining in a place where you can make a
hole in the roof.
Make a Ø19.5 mm round hole, or a 15mm
rectangular hole in the roof.
4
Mount the DAB antenna and fasten it by tightening
the nut from the inside.
5
Use a cable clamp to fix the antenna cable and
perform the wiring as far as the DAB hideaway unit.
100 mm – 200 mm
• In the case of a round fixing hole
DAB antenna
(Accessory7, 8)
Waterproof
rubber
(Accessory9)
Car roof
Nut (Accessory!)
• In the case of a rectangular fixing hole
DAB antenna
(Accessory7, 8)
Waterproof
rubber
(Accessory0)
Car roof
Nut (Accessory!)
Ø19.5 mm
15 mm
27
|
English