Connecting Cables To Terminals - Kenwood KTC-9090DAB Instruction Manual

Connecting Cables to Terminals

2CAUTION
• DC voltage is output from the DAB antenna terminal
of the DAB hideaway tuner to supply power to the
DAB antenna. Be sure to connect the supplied DAB
antenna only. Otherwise, the unit may be damaged.
DAB connection cable
(Accessory1)
D A B
K T C – 9 0 9 0 D A B
TO
HEAD UNIT
To control unit
Connection cable
(supplied with the
Disc changer)
Disc changer
If you want to connect KCA-S210A
Control unit
]"N"
O
PROTOCOL
26
|
English
Control unit
H I D E A W A Y T U N E R
24bit D.R.I.V.E.
TO RDI TO
CHANGER OUTPUT DAB ANTENNA
N OFF ON
AUX
AUX
SWITCH SWITCH
IN
TO TO TO
H/U CHANGER 1 CHANGER 2
To Kenwood disc changer / DAB control input
Power control/Motor
antenna control wire
(Blue/White)
DAB hideaway tuner
1
2
3
DAB antenna cable
(Accessory@)
RDI output
NOTE
• To use the data output from the Radio Data Interface (RDI) connector, a
separate RDI-enabled component is required.
• The Radio Data Interface (RDI) output may contain test data, but this isn't
broadcast data.
Kenwood disc changer control input
NOTE
• To connect the Disc changer, consult your Disc changer manual.
DAB hideaway tuner
TO TO
HEAD UNIT CHANGER
Disc changer
(*...commercially available)
FM/AM antenna input
P.CONT.
ANT.CONT.
FM/AM antenna cable*
FM/AM antenna
control cable*
(M10)
Connect the KTC-9090DAB to the terminal
labelled TO CHANGER 2.
NOTE
• Set the PROTOCOL selection switch to "N"
position.
DAB/FM/AM antenna
(Accessory7, 8)