Table of Contents
Advertisement
English
Tuner features (See page 5)
Funciton of the KRC-585
Switching Display for Tuner
You can change the display used when listening to the radio.
Changing the Display:
.
'
Each time you press the DISP button, the display changes as
follows:
Station frequency
Vv
SNPS name (only when being preset)
v
Clock
« When the switching clock display (P.33) is set to off, the display
will not switch to the clock display.
« The @ indicator lights while the clock is displayed.
Frequency Step Setting
gee
Switch the frequency step used in seeks. The factory defaults
are 50 kHz for FM and 9 kHz for AM.
While pressing buttons #1 and #5 at the same time, press the
reset button.
The frequency step settings will be changed to 200 kHz for FM
and 10 kHz for AM.
When you change the frequency step settings, all memory
contents will be erased.
Returning Frequency Step Settings to Original Values:
Repeat the operation as mentioned above.
| Station Name Preset (SNPS).
You can assign names to radio stations with the Station
Preset Memory. Up to 18 FM stations and 16 AM stations can
be assigned names.
1 Adjust the frequency to the station whose name you want to
enter.
2 Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.
3 Press either the ké< or BP button to move the cursor to the
desired position.
The ké<¢ button moves the cursor to the left, and the >»!
button to the right.
You can also move the cursor left or right by pressing the ke
or i
buttons, respectively, on the remote.
4 Each press of the ml button résults in the type of characters
that are to be entered changing between alphabet and
numeral/symbols.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.
Alphabet : A ~ Z
Numerals
and symbols : 1~90@"'*% &*+-=,./\<>[]
Direct Alphabet Input (Function of the KCA-R6A : Optional)
Direct input can made of letters (alphabetical) with the letter
entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".
pe Ae ol
ae ee
ey
ie
ie
5 Continue steps 3 and 4 until all. the characters are chosen for
the name.
You can enter up to 8 characters for each name.
6 e Assigning Names
Press the NAME.S button on the unit or the OK button on the
remote.
The name of the station is stored in memory, and the Station
— 20—
Advertisement
Table of Contents
