Dell PowerEdge C6145 Hardware Owner's Manual page 28

Hardware owner's manual
Hide thumbs Also See for PowerEdge C6145:
Table of Contents

Advertisement

b) Make sure BMC NIC under the IPMI configuration. If
Users should take their own risk if they set IP address by
themselves. Improper IP setting may cause that they cannot
implement communication with BMC over LAN.
2)
The remote clients should install ipmitool under their
operating systems.
3)
Execute IPMITOOL with BMC IP , username, password and
sol parameter like below format:
ipmotool –I <interface> -U <username> -P <password> -
H <Host iP> sol activate
4)
Remote users will have the ability to monitor server screen
synchronically through executing the super terminal
application.
COM2 is always workable no matter what kind of NIC is selected.
Users only need to make sure BMC current IP exists and IPMI
command through LAN is workable, then SOL is workable.
In Figure 1-7, BMC default shared-NIC port is item 3; BMC
dedicated port is item 8; and COM1 is item 5.
For detailed configuration of Console Redirection, please refer to "Remote
Access Configuration" on page 61.
28
|
Using the System Setup Program
users select dedicated NIC, make sure the LAN cable has
been plugged in the dedicated port.
 If users have the DHCP server, select BMC IP address
source to DHCP .
 If users set IP address source to static, enter the BMC
themselves in IP address-> IP address.

Advertisement

Table of Contents
loading

Table of Contents