Vlan Id - Dell PowerEdge C6100 Using Instruction

VLAN ID

Use the LAN configuration command parameter 14H to set or get the VLAN ID. For additional
information, refer to the IPMI v2.0 specifications.
Table 1-36. VLAN Commands
Commands
Set LAN Configuration
Parameters (Parameter 9 and 25 are not supported)
Get LAN Configuration
Parameters (Parameter 9 and 25 are not supported)
Table 1-37. LAN Configuration Parameter 14H
Parameter
802. 1q VLAN ID (12-bit)
Examples:
Set VLAN ID:
• Get LAN configuration parameter:
ipmitool 0xC0 0x02 0x01 0x14 0x00 0x00
Response: 0x00 0x11 0x01 0x80 (VLAN Enable and VLAN ID: 1)
• Set LAN configuration parameter:
ipmitool 0xC0 0x01 0x01 0x14 0x01 0x80
Response: 0x00
NetFn
Transport
Transport
# Parameter Data
14H Data 1
[7:0] — Least significant 8-bits of the VLAN ID. 00h if
VLAN ID not used.
Data 2
[7] — VLAN ID enable.
0b — Disabled
1b — Enabled
If enabled, the BMC will only accept packets for this
channel if they have 802.1q fields and their VLAN ID
matches the VLAN ID value given in this parameter.
[6:4] — Reserved
[3:0] — Most significant 4-bits of the VLAN ID
CMD O/M
01h M
02h M
Using the Baseboard Management Controller
Supported
Yes
Yes
45