B&K AVP3090 Owner's Manual page 12

9. Tape Loop
- Connections for the audio of a tape deck.
TAPE OUT- Provides a fixed level, buffered audio output for sending to a tape
TAPE IN -
10. V1 loop
-
V1 OUT -
V1 IN -
11. V2 loop
-
V2 OUT -
V2 IN -
12. CTRL OUT
- Output that allows you to remotely control external devices. This
12. IR IN -
player. Connect the TAPE OUT from the AVP to the TAPE IN on
the tape player.
Accepts audio output from a tape player. Connect the TAPE IN
from AVP to the TAPE OUT on the tape player.
Connections for the audio of a VCR designated as VCR 1.
Provides a fixed level, buffered audio output for sending to a VCR.
Connect the V1 OUT on the AVP to the AUDIO IN on the VCR.
Accepts audio output from a VCR. Connect the V1 IN on the AVP
to the AUDIO OUT on the VCR.
Connections for the audio of a VCR designated as VCR 2.
Provides a fixed level, buffered audio output for sending to a VCR
associated with Z2. Connect the V2 OUT on the AVP to the
AUDIO IN on the VCR.
Accepts audio output from a VCR. Connect the V2 IN on the AVP
to the AUDIO OUT on the VCR.
output is rated 12 VDC @ 15 mA continuous. The output goes high
(12 VDC) when the preamplifier is turned on, and low (0 VDC)
when the preamplifier is turned off. This output works with the B&K
amplifiers to remotely turn them on and off (amplifiers with the
control feature). Connect the CTRL OUT on the AVP to the CTRL
IN on the amplifier.
Accepts input from external IR receptors. Connect your IR
repeater to IR IN to control the AVP preamplifier when the front IR
receiver is blocked (by cabinet door) or to control the preamplifier
from another room (zone 2).
Page 10