Battery Installation And Charging - AT&T CL82350 Quick Start Manual

Battery installation and charging

Install the battery as shown below.
screen indicates the battery status (see table below). If necessary, place the
handset in the telephone base or charger to charge the battery. For best
performance, keep the handset in the telephone base or charger when not in
use. The battery is fully charged after 6 hours of continuous charging.
If the screen shows Low battery, you need to charge the handset without
interruption for at least 0 minutes to give the handset enough charge to use
the telephone for a short time.
charge indicators and actions to take.
Battery indicators
The screen is blank or shows
Place in charger.
The screen shows
Low battery and flashes.
The screen shows
HANDSET X.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
Insert the supplied
battery with the label
THIS SIDE UP facing up
as indicated.
Once you have installed the battery, the
The following table summarizes the battery
Battery status
Battery has no or very
little charge. The handset
cannot be used.
Battery has enough charge
to be used for a short time.
Battery is charged.

Action
Charge without interruption until
the screen shows Low battery or
HANDSET X (at least 0 minutes).
Charge without interruption until
the screen shows HANDSET X
(at least 0 minutes).
To keep the battery charged,
place it in the telephone base or
charger when not in use.
Step 2
Align the cover flat
against the battery
compartment, then
slide it upwards until
it clicks into place.