Wall Installation - AT&T 958 User Manual

958_book_1ATT 6/3 6/3/02
INSTALLATION

Wall Installation

1 Reposition the base wedge for wall use.
Make sure the pull-out feet are not extended. Press on the base
wedge as shown in figure a to remove the wedge. Turn the wedge
so that the larger end is toward the bottom of the telephone.
Reattach the wedge by positioning it as shown in figure c and
pressing in the direction of the arrows until it locks in place.
figure a
2 Connect the line cord to the telephone.
Plug the line cord into the jack labeled LINE and thread the
cord through the tabs under the phone as shown.
4
4:27 PM Page 4
figure b figure c