Table of Contents
Advertisement
Removing the Trim Panel
1 Lay the system on its cover as shown in Figure 1-7.
Figure 1-7. Removing the Trim Panel
hex-head Phillips screws (6)
2 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the side
of the trim panel. See Figure 1-7.
3 Using a #2 Phillips screwdriver or 1/4-inch nut driver, remove the three screws from the back
of the system.
4 Slide the trim panel backward and then remove the trim panel from the chassis.
5 If not already present on the system, install the six shoulder screws included with the kit,
attaching three screws to each side. See Figure 1-7.
NOTE:
The shoulder screws must be tightened firmly enough (10.8 to 13.2 in-lbs of torque) to
support the weight of the system in the rack and to prevent loosening.
The system is ready to install in the rack.
shoulder mounting
screws (6)
Tower-to-Rack Conversion Guide
15
Advertisement
Table of Contents
