Reversing The Cable-Management Arm Installation - Dell 4200 Rack Installation

(Rev. 9/8/00) FILE LOCATION: S:\SYSTEMS\MARCONI\Rackingd\7U\05KCEa00\05KCEeb0.fm
support.dell.com

Reversing the Cable-Management Arm Installation

1. Turn the cable-management arm over (see Figure 13).
pull pin
offset
hinge
rail-mounting
plate
Figure 13. Reversing the Cable-Management Arm
2. Remove the pull pins from the offset hinge of the cable-management arm.
3. Remove the rail-mounting plate.
NOTE: Make note of the orientation of the rail-mounting plate to the vertical rail.
4. Pull the hinge away from the cable-management arm assembly.
5. Position the offset hinge next to the cable-management arm assembly.
6. Replace the pull pin with the ring facing up.
7 . Replace the rail-mounting plate in the same orientation to the opposite vertical
rail.
8. Replace the second pull pin with the ring facing up.
9. Perform the steps to install the cable-management arm. The opposite vertical rail
and the slotted pocket on the opposite side of the cable tray are used for reverse
the installation of the cable-management arm.
DELL CONFIDENTIAL - Preliminary
latch pin
9/8/00
Rack Installation Guide 17