Installing The Trim Panel - Dell PowerEdge 4600 Manual

Installing the Trim Panel

To install the tower trim panel on the chassis, perform the following steps.
NOTE: You may find it convenient to leave the chassis in the rack position (as shown
1
NOTICE: You will need two to four persons to lift the system into position above the
2
3
4
5
6
1-10 Rac k - t o-To we r Co n v ers io n G ui d e
Lay the front panel on a smooth work surface with the outside surface facing
h
down.
Remove the two 6-32 x 0.25-inch hex-head Phillips screws that secure the control
i
panel board to the back of the front panel.
Set the control panel and screws aside for installation on the tower front panel.
in Figure 1-6) while installing the trim panel.
Hold the tower trim panel in position with the sides facing up as shown in Figure 1-6.
trim panel. One additional person may be needed to separate the trim panel from
chassis obstructions.
Using two or four persons, lift the system chassis.
Lower the system chassis into the trim panel (see Figure 1-6).
After the chassis is lowered into place, align the three holes in the trim panel with the
three holes in the chassis.
Secure the right side of the trim panel with three 6-32 x 0.25-inch hex-head Phillips
screws (see Figure 1-6).
Secure the back of the trim panel with three 6-32 x 0.25-inch hex-head Phillips screws.