Dell PowerEdge 4600 Manual page 12

Remove the system cover and set it aside (see Figure 1-5):
2
Loosen the three thumbscrews on the front of the system (see Figure 1-5).
a
Slide the system cover back and grasp the cover at both ends (see Figure 1-5).
b
Carefully lift the cover away from the system and set it aside.
c
F i g u r e 1 - 5 . R e m o v i n g t h e S y s t e m C o v e r
thumbscrews (3)
Remove the front panel:
3
Label and remove all hard drives (see your Installation and Troubleshooting
a
Guide).
Remove all power supplies (see your Installation and Troubleshooting Guide).
b
Remove the peripheral bay (see your Installation and Troubleshooting Guide).
c
Remove the bezel connector cable from the center of the control-panel board.
d
Remove the control panel's interface cable.
e
Remove the four T-10 Torx screws that secure the bezel attaching bracket to the
f
front panel.
Remove the 14 remaining T-10 Torx screws that secure the rack front panel to the
g
chassis.
Rac k - t o -To w e r C o n v e r s io n G u i d e
1-9