IMPORTANT:
key to have administrator-only access through the file. If the private key is compromised, the
administrator can delete the \hp\sslshare\cert.pem file and restart the server. This causes
HP SMH to generate a new certificate and private key.
NOTE:
Certificate and private key generation only occur the first time HP SMH is started or
when no certificate and key pair exist. You can use a certificate from a certificate authority (CA),
such as Verisign or Entrust, to replace a self-generated certificate. These certificates and key files
are shared with other HP management software, such as HP Systems Insight Manager.
Configure the Management Agents
This section describes the configuration of the HP Insight Management Agents on Integrity
servers. The management agents are a collection of services that report system information and
status to the SMH application. After configuring the agents you can use
Management Agents"
NOTE:
HP management agents require TCP/IP and SNMP on the system.
Activate and Deactivate Agents
Agents are activated when they are installed (except for Clustering Information agents). Inactive
agents remain installed but are dormant until you reactivate them. To activate or deactivate an
agent, complete the following steps:
1.
Log in with Administrator rights. You must have Admin rights to access the management
agents from the Windows Control Panel.
2.
Open the Windows Control Panel and select HP Management Agents for Integrity Servers.
The installed agents are listed in the window. All agents except clustering information are
activated at installation.
Figure 3-5 Services tab
3.
From the Services tab, select an agent from either column to change the active or inactive
status.
4.
Click Add or Remove to change the status of the selected agent.
5.
Click OK when you have made all required status changes.
66
Installing and Configuring the Management Tools
For Windows operating systems, the file system must be NTFS for the private
to see what each agent does.
Appendix D "SMH and