Managed Server - HP Integrity rx4610 Installation Manual

Chapter 1
To monitor and control managed servers, you can use either the ISC Stand-alone
Console that is included during ISC installation or a supported Enterprise System
Management Console (ESMC). Two supported ESMC applications exist:
• Hewlett-Packard OpenView
• Computer Associates Unicenter
NOTE Platform Instrumentation software on managed servers does
not support Simple Network Management Protocol (SNMP)
traps. Consequently, supported ESMCs will not receive these
traps from managed servers.
Also, Itanium - based platforms running Microsoft Windows
64-bit Advanced Server do not support the integration of either
the Hewlett-Packard OpenView Network Node Manager
Console or the Computer Associates Unicenter The Next
Generation.
The ISC Stand-alone Console can monitor and control managed servers without a
third-party management application. This console is implemented as an ActiveX
control that runs within its own container or within a third-party container
application such as Microsoft Management Console (MMC), Internet Explorer
v5.0 or later, or Netscape Navigator
The ISC Stand-alone Console can exist and run separately on the client
workstation even if it have a supported ESMC application installed.
NOTE Client workstation requirements can change beyond those
listed in Table 1 when you use ISC with a supported ESMC.
Please refer to the ESMC application's installation
requirements for additional information.

Managed Server

The managed server runs instrumentation software (platform instrumentation).
Console software running on the client workstation communicates with
instrumentation software to monitor and control the managed server. Table 2 lists
the system configuration on which the ISC installation process installs
instrumentation software and also lists the managed server's configuration
requirements:
Table 2. Managed Server System Requirements
System Configuration
Itanium - based platform running
Microsoft Windows 64-bit
Advanced Server
2
†
Network Node Manager 6.2 for Windows NT
†
The Next Generation 2.2.1 for Windows NT
†
v4.0 or later with the ActiveX snap-in.
Requirements
•
At least 512 MB of RAM.
•
At least 150 MB of available disk space.
System Requirements
†
†