System Requirements; Client Workstation - HP Integrity rx4610 Installation Manual

1 System Requirements

ISC consists of console software and instrumentation software. You install and
run console software on the system from which you are going to monitor and
control other servers referred to as managed servers. A managed server is an
®
Intel Architecture (IA) platform with ISC Platform Instrumentation software
installed and running. The system running the console software is sometimes
referred to as the client workstation or client.

Client Workstation

The client workstation runs console software. The console software is installed
during ISC installation. Table 1 lists the system configurations on which the ISC
installation process installs console software and also lists the client workstation's
configuration requirements and restrictions:
Table 1. Client Workstation Configuration Requirements and Restrictions
System Configuration
IA-32 platforms running
Windows 2000
Itanium™ - based
platforms running
Microsoft Windows
64-bit Advanced Server
IA-32 platforms running
Windows NT † 4.0 server
or workstation, Enterprise
Edition
Requirements
•
Intel Pentium microprocessor or higher.
•
At least 64 MB of RAM.
•
At least 150 MB of available disk space.
•
Microsoft Windows compatible modem must be used
if you connect to the server by modem.
•
Service Pack 2 must be installed.
•
Supported console for DPC only.
Intel ® Itanium microprocessor.
•
•
At least 512 MB of RAM.
•
At least 150 MB of available disk space.
•
Microsoft Windows compatible modem must be used
if you connect to the server by modem.
•
Supported console for DPC only.
•
Windows 2000/NT Server, or Workstation 4.0 (Service
Pack 6a), or Enterprise Edition.
•
Intel Pentium microprocessor or higher.
•
At least 64 MB of RAM.
•
At least 150 MB of available disk space.
•
For Windows NT, Remote Access Service must also
be installed. If it is not installed, the Direct Platform
Control (DPC) component will not install.
•
Microsoft Windows compatible modem must be used
if you connect to the server by modem.
•
No support for Java-based Platform Instrumentation
Control (PIC).
1