Selecting And Checking The Input Mode; Adjusting The Volume; Turning Off The Power - Sharp XG-NV5XB Operation Manual

Basic Operations
Projector
On-screen Display
f
f
7a
8
E-19
7a
VOL
ON
MUTE
OFF
BLACK
SCREEN LASER
7b
TOOLS MENU
8
6
R-CLICK ENTER
INPUT IrCOM
FREEZE AUTO SYNC
To view the image from a
source connected to:
s COMPUTER INPUT 1
COMPUTER INPUT 2
VIDEO INPUT
7b
6 Selecting and Checking the Input
Mode
Press INPUT on the projector or the "Power" remote
control to select the desired input mode. Press it again
to change the mode as shown on the left.
• When no signal is being received, "No Signal" will be
displayed. When a signal that the projector is not preset to
receive is being received, "Not Reg." will be displayed.
• The picture size and aspect ratio differ in "COMPUTER",
"PAL", "SECAM" and "NTSC" modes.

7 Adjusting the Volume

a. Press VOLUME /VOLUME
or the "Power" remote control to adjust the volume.
b. Press MUTE on the projector or the "Power"
remote control to temporarily turn off the sound.
Press MUTE again to turn the sound back on.

8 Turning off the Power

1. Press POWER OFF on the projector or the
"Power" remote control. The screen on the left will
appear.
2. Press POWER OFF again while the screen is
displayed.
• If you accidentally pressed POWER OFF and do not want
to turn off the power, wait until the power off screen shown
on the left disappears.
When POWER OFF is pressed twice, the POWER indicator
will light up red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.
The power can be turned on again by pressing POWER
ON on the projector or the "Power" remote control. When
the power is turned on, the POWER indicator and the LAMP
REPLACEMENT indicator light green.
• The POWER indicator flashes if the bottom filter cover is
not securely installed.
on the projector