Personalizing The Projector Menu Display; Locking Control Keys; Turning The Projector Off - BenQ W1070 User Manual

Personalizing the projector menu display

The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do
not affect the projection settings, operation, or performance.
• Menu Display Time in the System Setup : Basic > Menu Settings menu sets the length of time
the OSD will remain active after your last key press. Use
• Menu Position in the System Setup : Basic > Menu Settings menu sets the OSD position in
five locations. Use
• Language in the System Setup : Basic menu sets your familiar language for the On-Screen (OSD)
Menus. See "Using the menus" on page 26
• Splash Screen in the System Setup : Basic menu sets a preferred logo screen to be displayed
during projector start-up.

Locking control keys

With the control keys on the remote control and projector locked, you can prevent your projector
settings from being changed accidentally (by children, for example). When Key Lock is on, no control
keys on the remote control and projector will operate except POWER and
To lock the keys:
1. Press MENU/EXIT and then press
2. Press to highlight Key Lock, and press
and press MODE/ENTER. The control keys lock.
To unlock the keys, press and hold

Turning the projector off

To turn the projector off, press POWER
appears. Press POWER
• The Power indicator light flashes orange and the fans run for
about two minutes to cool the lamp. The projector will not
respond to any commands until the cooling process is complete.
Once the cooling process finishes, a "Power Off Ring Tone"
will be heard.
To turn off the ring tone, see
• Then, the Power indicator light is a steady orange once the cooling process has finished and fans stop.
• If the projector will not be used for an extended period, unplug the power cable from the power
outlet.
• To protect the lamp, the projector will not respond to any commands during the cooling process.
Actual lamp life may vary due to different environmental conditions and usage.
/ to select a preferred position.
for details.
/ until the System Setup : Advanced menu is highlighted.
on the projector or remote control for 3 seconds.
and a warning message
again.
"Turning off the Power On/Off Ring Tone" on page 35
/ to select a suitable time length.
/ to select On. A warning message appears. Select Yes
.
for details.
Using the projector 39