Resetting The Lamp Timer - BenQ SP890 User Manual

Resetting the lamp timer

Do not reset the lamp timer if the lamp has not been replaced as this could cause damage.
1. After the start-up logo, press MENU on the projector or MENU/EXIT
on the remote control, and then press
menu is highlighted.
2. Press to highlight Lamp Settings and press ENTER. The Lamp
Settings page is displayed.
3. Highlight Reset Lamp Timer and press ENTER. A warning message is
displayed asking if you want to reset the lamp timer. Highlight Reset
and press ENTER. The lamp time will be reset to "0".
54 Additional information
/ until the Advanced Setup Advanced Setup
Lamp Settings ENTER
HDMI Settings
Baud Rate 115200
Test Pattern
High Altitude Mode Off
Audio Settings
Password
Lan Control Settings
Reset All Settings
Expert Mode
Direct Power On Off
S-Video EXIT Back
Lamp Settings
Normal
Lamp Power
ENTER
Reset Lamp Timer
Equivalent Lamp Hour
EXIT Back
WARNING
Reset Lamp Timer?
Reset Cancel