Konica Minolta magicolor 5670EN Reference Manual page 220

2
Turn on the power of the machine while it is connected to the network.
Since the printer is searched for, be sure to connect the machine to
the network.
3
To use the Web service print, check that [Network discovery] is enabled in
[Network and Sharing Center] on the computer.
4
Open the [Network] window.
In Windows Vista/Server 2008, click [Start], and [Network].
In Windows 7/Server 2008 R2, open [Computer] and click [Network].
If [Network] is not displayed in [Computer], click the [Network and
Internet] category on the [Control Panel], and also click [View network
computers and devices].
Connected computers and devices are detected.
5
Select the device name of the machine, and then click [Install] on the tool-
bar.
The printer driver for this machine is detected and the machine is ready to
print.
6
After finishing the installation, make sure that the icon for the installed
printer is displayed in the [Printers] or [Devices and Printers] window.
If the printer driver is not correctly installed, the driver must be
updated using [Update Driver ...]. For details, refer to "Updating the
driver after connecting this machine" on page 208.
In Windows Vista/Server 2008, you can continue the task and
specify the printer driver installation disk to install the printer driver
if it is not installed in advance.
When the [Found New Hardware] window appears, follow the dis-
played messages to perform the procedure. For details, refer to
"Adding a printer from the Network window" on page 201.
In Windows 7/Server 2008 R2, you cannot specify the installation
disk after the machine is connected to the computer. Install the
printer driver in advance (Step 1).
200 Network Printing