Table of Contents
Advertisement
SA-VAM2+ Removal and Installation
Slide the new SA-VAM2+ into the port adapter slot until it is seated in the router midplane.
Step 6
Do not allow the SA-VAM2+ components to come in contact with the system board or the SA-VAM2+
Caution
could be damaged.
After the SA-VAM2+ is properly seated, lock the SA-VAM2+ in place, as shown in
Step 7
If a retaining lever does not move to the locked position, the SA-VAM2+ is not completely seated in the
Note
midplane. Carefully pull the SA-VAM2+ out of the slot, reinsert it, and move the retaining lever or other
mechanism to the locked position. See
To ensure the proper flow of cooling air across the internal components, make sure a blank service
Caution
adapter filler is installed in any unoccupied port adapter slots (part number 800-20675-01).
If you powered off the router:
Step 8
a.
b.
Cisco 7301 Router
Use
The Cisco 7301 supports a single SA-VAM2+ or port adapter.
Note
Figure 3-6
VPN Acceleration Module 2+ (VAM2+) Installation and Configuration Guide
3-6
Reattach the power cable, and place the cable through any cable support brackets.
Power on the router by turning the power switch to the on position.
Figure 3-6
and follow the steps below to remove and insert an SA-VAM2+ in the Cisco 7301 router:
Cisco 7301 Port Adapter/SA-VAM2+ Slot
3
GIGAB IT ETHER
SLOT 1
RJ45 EN
ATM
CIS CO 730
1
1
2
Figure
3-4.
NET 0/0
GIGAB IT ETHER
LINK
NET 0/1
TX
RJ45 EN
GBIC
GIGAB IT ETHER
RX
LINK
NET 0/2
TX
RJ45 EN
GBIC
RX
LINK
AUX
CONS OLE
TX
GBIC
RX
100-2 40V,
2A, 50/60
24V= 9A,
Hz
48 - 60V=
ALAR M
5A
COMP ACT
FLASH
STATU S
4
Chapter 3
Removing and Installing the SA-VAM2+
Figure
3-4.
OL-5979-03
Advertisement
Table of Contents
