Cables, Connectors, And Pinouts - Cisco SA-VAM - VPN Acceleration Module Installation And Configuration Manual

Cables, Connectors, and Pinouts

Table 1-3
2
3
The following conditions must be met before the enabled LED goes on:
•
•
If either of these conditions is not met, or if the router initialization fails for other reasons, the enabled
LED does not go on.
Port Adapter Jacket Card
The Port Adapter Jacket Card has two LEDs, as shown in
functions of the LEDs.
Figure 1-4
1
2
1
2
3
Table 1-4
LED
ENABLE
PWR (power)
Cables, Connectors, and Pinouts
There are no interfaces on the SA-VAM2+, so there are no cables, connectors, or pinouts.
VPN Acceleration Module 2+ (VAM2+) Installation and Configuration Guide
1-8
SA-VAM2+ LEDs
LED Label Color State
BOOT Amber On
ERROR Amber On
The SA-VAM2+ is correctly connected to the backplane and receiving power.
The system bus recognizes the SA-VAM2+.
Port Adapter Jacket Card Faceplate
4
3
Captive installation screw
ENABLE LED
PWR (power) LED
Port Adapter Jacket Card LEDs
Color
Green
Off
Green
Off
Function
Indicates the SA-VAM2+ is operating.
Indicates an encryption error has occurred. This LED is
normally off.
Figure 1-4.
5
4 Handle
5 Port adapter (SA-VAM2+) slot
Indicates
Port Adapter Jacket Card is enabled for operation.
Port Adapter Jacket Card is not enabled for operation.
Port Adapter Card is receiving power.
Port Adapter Card is not receiving power.
Chapter 1 Overview
Table 1-3 lists the colors and
1
PORT ADAPTER JACKET CARD
4
OL-5979-03