Accessibility - Konica Minolta bizhub 36 User Manual

4.3 Utility/Counter

Accessibility

This section describes the procedures for configuring settings for the Control Panel and adjusting the Touch
Panel.
Page 1/2
Page 2/2
Settings
[Key Repeat /Interval]
[Sound Settings]
bizhub 42/36
The length of time until the value begins to change after a Touch Panel
button is held down and the length of time for the value to change can be
specified.
• [Time to Start]: Specify the length of time until a value begins to change
after a button is held down.
• [Key Interval]: Specify the length of time for the value to change.
[Set All]
• [Enable]: Specify [ON] or [OFF] to output all sounds.
• [Volume]: To adjust the volume, press [Low], [Medium], or [High].
Configure the settings for sounding associated with key operations. The
following sound setting functions are available. To produce a sound, press
[ON], and then select the volume from [Low], [Medium] and [High]. To not
produce a sound, press [OFF].
[Operation Confirmation]
• [Input Confirmation Sound]: A sound produced when a key in the Con-
trol Panel or a button in the Touch Panel is pressed for an entry
• [Invalid Input Sound]: A sound produced for invalid button operation in
the Control Panel or the Touch Panel
• [Basic Sound]: A sound produced when the default value item is select-
ed for an option subject to rotational switching
[Successful Completion]
• [Operation Completion]: A sound produced when the operation has
completed normally
• [Transmission Completion]: A sound produced when a communica-
tions-related operation is completed normally
[Completion Preparation]: A sound produced when a device is ready
4
4-9