Back Panel; Side Panel - NETGEAR WNR1000v3 - Wireless- N Router Setup Manual

Back Panel

The router back panel, shown in
Figure 2
Viewed from left to right, the rear panel contains the following elements:
1. Restore factory settings button. Press for approximately 5 seconds to reset the router to the
factory default settings.
2. Four Local Area Network (LAN) 10/100 Mbps Ethernet ports for connecting the router to
your local computers
3. Internet/Wide Area Network (WAN) Ethernet port for connecting the router to a cable or DSL
modem.
4. Power on/off push-button.
5. AC power adapter outlet for connecting the power adapter.

Side Panel

The router side panel is shown in
Getting to Know Your Wireless Router
Figure 2, contains port connections.
2
1
Figure 3.
4
3 5
4