NETGEAR WNR1000v3 - Wireless- N Router Setup Manual page 7

You can use the status lights to verify various conditions.
Table 1. Status Light Descriptions
Label Activity
Solid Amber
Solid Green
Blinking Amber
1. Power
Blinking Green
Off
Solid Green
2. Push 'N'
Blinking Green
Connect
Off
Solid Amber
Solid Green
3. Internet
Blinking
Off
Solid Blue
Blinking Blue
4. Wireless
Off
Solid Green
Blinking Green
5. LAN
Solid Amber
(Ports 1–4)
Blinking Amber
Off
Getting to Know Your Wireless Router
Description
The router is performing the power-on self-test diagnostic.
The power is on and the router is ready.
A software update is in progress.
Firmware is corrupted. See
page 25 for instructions on restoring your router firmware.
Power is not being supplied to the router
Indicates that wireless security is enabled.
A WPS-capable device is connecting to or managing the router.
No WPS connection exists.
The Internet port is connected, but no IP address has been acquired.
The wireless router has acquired an Internet address.
Data is being communicated through the Internet port.
No Ethernet cable is connected to the modem.
The wireless interface is enabled.
Data is being communicated over the wireless network.
The wireless interface is turned off.
The local port is connected to a 100 Mbps device.
Data is being transmitted at 100 Mbps.
The local port is connected to a 10 Mbps device.
Data is being transmitted at 10 Mbps.
No link is detected on this port.
"Checking Basic Router Functions" on
3